Audiophilepure

Read Here

” The PS-HX500 achieves this by arriving with a pre-installed moving-magnet cartridge that’s already fully aligned and ready to go. Out of the box, all you have to do is install the platter while looping the rubber drive belt around the motor pulley and then top it off with its thick rubber mat. For the tonearm, you just put on the counterweight, balance the arm, and dial in the tracking force. The manual takes you through the steps if you’re not familiar with the process, but it’s designed so you can’t go too far wrong. Finally, you plug in the wall-wart power supply and audio output cables, and you’ll be ready to go. I double-checked the alignment of the cartridge and can report that it was installed perfectly, with absolutely spot-on overhang and zenith. The tracking force readout was accurate, and the anti-skating control dialed in the correct amount of bias.”

Comments are closed.