Audiophilepure

https://www.stereophile.com/content/schiit-audio-sol-turntable

I’m not going to go into much detail here—just watch the videos—but here’s how the setup process works, in a nutshell. Unpack the box and put the plinth on a level surface. Locate the platter and the bearing shaft and gently press the latter into the center well of the former; twist it slightly to secure. Now lower the platter/shaft assembly so that the inverted bearing goes down over the spindle; make sure that the ball bearing is in place. Attach the two power cables (“in” from the wall wart and “out” to the motor unit). Place the motor about an inch away from the platter then loop the rubber belt around the motor pulley; hold the belt against the edge of the platter and rotate to thread the belt onto the platter.

Comments are closed.